This set consists of:

• Brass bushing 8 x 1.5 x 6.2; Ref.: B40-1571
• Countersunk screw M5x16 - 8.8; ISO 10642 Ref.: L01-1012
• Polystop nut M5-8 DIN 985; Ref.: L01-0703
• Washer 5x10x0.5 mm DIN 988; Ref.: L01-0390

This set contains all the parts required to attach the handle to the connecting rod.
Note: An additional set is required to attach the handle to the canopy frame.

This kit is composed of:

• Shim washer 6 x 12 x 0.5; ref: B40-1479
• Brass bush 8 x 1 x 11.1; ref: B40-0438
• Polystop nut M6-8 DIN 985; ref: L01-0129
• Spring washer B8 DIN 137; ref: L01-0967

This kit contains all the hardware required for the fixation of the handle to the canopy frame. 

Note: another set is required to fix the handle to the rode.

This grey PVC plate is used as a guide for the Duo DiscusxL and xLT and Arcus.

Dimensions: 233×25 mm.

Please note: the model used for the Duo Discus and Nimbus-4D is shorter (ref. B40-3305). You can find it in the suggested products below.

This grey PVC plate is used as a guide for the Duo Discus and Nimbus-4D.

Dimensions: 220 × 25 mm.

Please note: the model used for the Duo Discus XL, Arcus, and Nimbus-4DL is longer (ref. B40-3306). You can find it in the suggested products below.

Gasket for the canopy frame of single-seat gliders, sold by the metre.

Please note: some gliders have this gasket on one side only, with a different seal on the other side (the one used for the two-seaters, see recommanded product). Please check your glider carefully before ordering.

This support is used on a fuselage side, to fixe the rear headrest. 

It is composed of the headrest holder, the locking plate, the 7.2mm bolt and the part that connect to the fuselage.

 

This battery holders is installed on the rear side of the front pilot seat, close to the aft pilot’s leg area. 

The metalic bracket is available in the suggested products section at the bottom of the page.

This bracket is designed for the battery holders installed on the rear side of the front pilot seat, close to the aft pilot’s leg area. 

The full box is available in the suggested products section at the bottom of the page.

This tension spring (ref RZ-124) is used in the rudder pedal of the Arcus, Duo Discus, and Nimbus-4D gliders, in the rear position, with two springs installed per glider. It is also used for the doors of the engine box in single seater.