This support is used for the lower rudder of the Arcus M.

The EASA Form one is included.

This wheel is made by Tost for the tail of the Arcus M, Ventus-3M and the Quintus M.

It is made in two parts, and it is adapted for a 12 mm axle and 200 x 50 tyres and tubes. In aluminium, silver anodized, it weights less than a kilo.

This cover is designed to fit the TOST Mini 150 wheel.

If your glider is currently equipped with a classic Schempp-Hirth tailwheel, you can upgrade to the more compact TOST Mini 150. To make this conversion, you'll need this cover, a TOST Mini wheel, and a set of washers. All required components are listed below.

This rubber skid is 330 x 70mm and it is adapted to all Schempp-Hirth gliders including Cirrus and Nimbus.

 

This threaded rod is M8 and 186mm long.

It is use for the trim of the Duo Discus, Duo Discus xL, Arcus, Nimbus-4D and Nimbus-4DL. The system on the Arcus edition 2020 is different.

This item is part of the stabilizer fixation of all the modern Schempp-Hirth gliders.

It is possible to replace or change it for a bigger pin diameter to compensate the ageing of the parts on the stabilizer.

This item is delivered with 4 allen screw M06x30 - 8.8, DIN 912 / ISO 4762 galvanized (L01-0119) and 4 Schnorr-safety washer M6 (L01-0378).

This part can be adapted to fit the Duo Discus, Duo Discus X, Duo Discus XL, as well as the Arcus, Arcus Edition 2020, and Nimbus-4D.

It measures approximately 147 mm in width and 157 mm in length.

Please note that the part is sold in an untrimmed form, so you will need to cut it to ensure a proper fit for your glider.

This kit includes a wide selection of spacer washers for tail wheel axle, measuring 16 x 2 mm with widths ranging from 1.5 to 6 mm. It is particularly useful if you plan to switch from a classic tailwheel to a mini version. Compatible with most gliders, except for the Arcus M, Ventus-3M, and Cirrus.

This part can be adapted to fit the Discus-2a, Discus-2b, Discus-2c, Ventus-2ax, Ventus-2bx, the ventus-2c, the ventus-2cx and the Ventus-3.

It measures 148 mm in width. 

Please note that you will need to cut the part to ensure it fits your glider, as it is sold in an untrimmed form.

This item is part of the horizontal tailplane fixation back system of all the modern Schempp-Hirth gliders. The kit provides all the necessary parts to change 1 pin.

The Schempp-Hirth iconic tool with an extra pin to dismantle the wingtip and an extra tool for the ballast plugs.

This rubber boot surrounds the upper part of the elevator rope.

It is 70 mm long and 75 mm large and the diameters of the openings are 65 and 18 mm.