Gasket for the canopy frame of single-seat gliders, sold by the metre.

Please note: some gliders have this gasket on one side only, with a different seal on the other side (the one used for the two-seaters, see recommanded product). Please check your glider carefully before ordering.

This connection fitting is used, sometime, to the Polyflex hose of the classic Duo Discus which are using the Classic wheel from TOST with a Magura cylinder brake.

This support is used on a fuselage side, to fixe the rear headrest. 

It is composed of the headrest holder, the locking plate, the 7.2mm bolt and the part that connect to the fuselage.

 

The tension spring is used for the retraction of the landing gear of all the Discus, Discus-2, Ventus, Ventus-2 and the Nimbus-4.

Its dimensions are 1,6 x 12,7 x 164,5 mm.

Protective cover for the main pin made of Supra-Tex. Designed to store and protect the main pin from dirt and damage while the glider is not rigged.

 

These replacement springs are specifically designed for use with the BWS Garagewiper system. Each set is sold as a matched pair for the left and right wiper units.

Important compatibility note:
These springs are not compatible with the classic Flexiwiper model.

This service applies when our team enters an order by phone on the customer’s behalf. It is used only in special cases where personal assistance is required. 

This gummi piece is used to connect the spark plug in the SOLO 2625 and 2350 engines.

SOLO spare part n° 23 00 701 V1

This part was originally black, then changed to red, and has now been superseded by this new reference.

This battery holders is installed on the rear side of the front pilot seat, close to the aft pilot’s leg area. 

The metalic bracket is available in the suggested products section at the bottom of the page.