Safety nut, DIN 985 galvanized

Availabe in thread size M6 or M8.

These roll pins are used to secure the aileron.

Dimension: 2 x 10 mm

DIN 1481 / ISO 8752

Washer M06 galvanized, DIN 125 / ISO 7090 Form B

This gasket is used for the canopy of the Duo Discus and the Arcus.

It is sold by the meter.

This is the handle for the trim of the Arcus, Duo Discus XL and Nimbus-4DL.

The roll pins are included. 

Please note the pin roll can be bought separatly (see suggested product). If your glider is older than April 2015, you need to use the 2x14 mm roll pins instead of 2x16 mm.

 

This spring is used for the trim of the Arcus, Duo Discus XL, Nimbus-4DL and all the Discus from the Discus a to the Discus-2c.

It is 25mm lage and the legs are 40mm long. The central part is 12,5mm.

Some glider need roll pins. They are not included but they can be baught individaly (see the suggested products). 

Roll pin DIN 1481 / ISO 8752 stainless.

They are (mainly) used to in trim of the Arcus, Duo Discus XL and Nimbus-4DL.

There is two models : On gliders produced after April 2015, you will probably need the 2 x 16 mm model. For the older glider you will need to use the 2x14 mm roll pins. Please have a look in your glider to confirm which models you need.

 

Rod end bearing with a 14c6 head and M8 x 58 length body.

Other rod end bearings are used in our gliders. If you are not sure which one you need. Please contact the Spare Part team.

SOLO Silent block bush, spare part n° 20 61 395

 

This piece is used to protect the spark plug from the rain in the SOLO 2350 engine.

SOLO spare part n° 00 84 203

Safety washers Form S available in M6 and M8.

These washers are used, among other things, to secure the rear part of the horizontal tail fitting and the elevator drive U-bracket.

This kit contains all the fuel hoses that need to be replaced during the 5 years inspection on the Arcus M.

These fuses are used for instruments.

They are available in 2, 4 and 6,3 A.

This sensor is used in the Solo 2625 01 and 2625 02 to measure the water temperature.

The sensor used on the Arcus M and Ventus-3M (Solo 2625 01i and 02i) is different. You can find it on the suggested products.

This hoses are assembled with a filter and the connections to refuel your glider.

This RPM sensor with cables and pins is used for the Solo 2625-02i.

This M8 screw is design for the steering tail wheel axle of the Arcus-M and the Ventus-3M.

 

This axle is design for the steering tail wheel of the Arcus-M and the Ventus-3M.

 

This air filter RU 2690 (Solo ref: 25 00 580) is used for the Solo 2625-01 and 2625-02.

This tension spring is 1,02 x 11 x 72 mm.

It is used for the arresting cables of the Ventus-2cT, -2cxT and Discus-2cT with engine Solo 2350.

 

This 6PR tire from TOST AERO is used for all the 200x50 mm tailwheels and it is adapted to a large majority of modern Schempp-Hirth gliders.