This 6k-Screw is mainly used at the rear part of the horizontal tail fitting.
 

This 6k-Screw is used for the airbrake drive funnel of the Ventus-2 and Discus-2c.

This 6k-Screw is used for the airbrake drive funnel of the Ventus-2c and Discus-2c.

This part is used for the notching of the flaps of the Ventus-2bx, Ventus-2c and Ventus-2cx.

It is 146 mm long and the screw holes are spaced 50 and 69 mm apart respectively.

This wheel is made by Tost for the tail of the Arcus M, Ventus-3M and the Quintus M.

It is made in two parts, and it is adapted for a 12 mm axle and 200 x 50 tyres and tubes. In aluminium, silver anodized, it weights less than a kilo.

This washer is  16 x 2 x 4,5 mm and it is used for the tail wheel 

This item is part of the stabilizer fixation of all the modern Schempp-Hirth gliders.

It is possible to replace or change it for a bigger pin diameter to compensate the ageing of the parts on the stabilizer.

This item is delivered with 4 allen screw M06x30 - 8.8, DIN 912 / ISO 4762 galvanized (L01-0119) and 4 Schnorr-safety washer M6 (L01-0378).

This perspex disc is made for Arcus, all Duo Discus, Ventus-3, Discus-2b, -2c, Discus b and cs.

However, some gliders have more than one perspex disc and they can be different. Please look at the diameter and model you need.

Its diameter is 78,3 mm and the central hole is 5 mm.

This perspex disc is made for the Ventus-2a.

Its diameter is 53,5 mm and the central hole is 5 mm.

This gas strut is 450 N and 178 mm long.

It is used for the foldable instrument panel of Arcus and Duo Discus XL.

This 350 N gas strut is 293 mm long.

It is used for the foldable instrument panel of the Ventus-2c, Ventus-2bx, Discus-2a, Discus-2b and Discus-2c. 

This 300 N gas strut is 313 mm long.

It is used for the foldable instr. panel of the Discus-2c FES, Discus b, Ventus c and Ventus-2b.

This rubber boot is surrounding the water ballast control rod to avoid the water leaking through. It is used in several Schempp-Hirth gliders including the Nimbus-2, Ventus, Ventus-2c, Discus-2c, Duo Discus and the Arcus.

It is 125 x 22 x 22 mm with a 7 mm and a 16 mm opening.

Over the years, other bellows and different combinations have been used. You can find them underneath this description, in the "suggested products", if you want to compare them with the model that you wish to replace.

This part is used for the notching of the flaps of the Ventus-2b.

It is 135 mm long and the screw holes are spaced 50 and 69 mm apart respectively.

This part is used for the notching of the flaps of the Ventus c.

It is 135 mm long and the screw holes are spaced 50 and 68 mm apart respectively. The space between the first and the last step is 90 mm. Please look carefully at the drawing to make sure that it is really the part you need.

This item is part of the horizontal tailplane fixation back system of all the modern Schempp-Hirth gliders. The kit provides all the necessary parts to change 1 pin.