This 6k-Screw is mainly used at the rear part of the horizontal tail fitting.
 

The Schempp-Hirth iconic tool!

This item is part of the horizontal tailplane fixation back system of all the modern Schempp-Hirth gliders. The kit provides all the necessary parts to change 1 pin.

This item is part of the stabilizer fixation of all the modern Schempp-Hirth gliders.

It is possible to replace or change it for a bigger pin diameter to compensate the ageing of the parts on the stabilizer.

This item is delivered with 4 allen screw M06x30 - 8.8, DIN 912 / ISO 4762 galvanized (L01-0119) and 4 Schnorr-safety washer M6 (L01-0378).

This washer is used for the tail ballast dump valve of most of the Schempp-Hirth gliders.

This 6k-screw is used for the elevator drive U-bracket.
 

This part can be adapted to fit the Duo Discus, Duo Discus X, Duo Discus XL, as well as the Arcus, Arcus Edition 2020, and Nimbus-4D.

It measures approximately 147 mm in width and 157 mm in length.

Please note that the part is sold in an untrimmed form, so you will need to cut it to ensure a proper fit for your glider.

This part can be adapted to fit the Discus-2a, Discus-2b, Discus-2c, Ventus-2ax, Ventus-2bx, the ventus-2c, the ventus-2cx and the Ventus-3.

It measures 148 mm in width. 

Please note that you will need to cut the part to ensure it fits your glider, as it is sold in an untrimmed form.

This threaded rod is M8 and 186mm long.

It is use for the trim of the Duo Discus, Duo Discus xL, Arcus, Nimbus-4D and Nimbus-4DL. The system on the Arcus edition 2020 is different.