This oval countersunk head screw is used for the seat pan.

It is size M 5 x 16.

The canopy window rail device including screws. The screws are in metal but as an option, you can order it in plastic.

These rails are made for the Mecaplex canopy. It is the only model currently available, but you may need to customise it a little if you have a Weis canopy.

 

This gasket is used for the canopy of the Duo Discus and the Arcus.

It is sold by the meter.

This is the handle for the trim of the Arcus, Duo Discus XL and Nimbus-4DL.

The roll pins are included. 

Please note the pin roll can be bought separatly (see suggested product). If your glider is older than April 2015, you need to use the 2x14 mm roll pins instead of 2x16 mm.

 

This spring is used for the trim of the Arcus, Duo Discus XL, Nimbus-4DL and all the Discus from the Discus a to the Discus-2c.

It is 25mm lage and the legs are 40mm long. The central part is 12,5mm.

Some glider need roll pins. They are not included but they can be baught individaly (see the suggested products). 

Roll pin DIN 1481 / ISO 8752 stainless.

They are (mainly) used to in trim of the Arcus, Duo Discus XL and Nimbus-4DL.

There is two models : On gliders produced after April 2015, you will probably need the 2 x 16 mm model. For the older glider you will need to use the 2x14 mm roll pins. Please have a look in your glider to confirm which models you need.

 

These fuses are used for instruments.

They are available in 2, 4 and 6,3 A.

Thees oxygen bottle holders are suitable for a majority of pure Schempp-Hirth gliders.

Please choose which holder you need according to the diameter of your Oxygen-bottle.  It is possible to adjust the holder at +/- 2mm.

In single-seaters, one of the screws of the holder is often above the spar bridge, where the wall is relatively thin. It is therefore often necessary to add the washer B40-2218 (see suggested products).