Tail
-
Bellows V6-905 for the fin tank
This rubber boot ensures the sealing of the tail ballast of most of the Schempp-Hirth gliders.
It is advisable to replace it every 2-3 years to avoid water leaks.Its dimensions are 72 x 38 mm.
from 1 € 18.31 incl. 19% VAT
€ 15.39 -
Rubber washer 19x3 mm for the fin tank dump valve
This rubber washer ensures the sealing of the tail ballast of most of the Schempp-Hirth gliders.
It is advisable to replace it every 4-6 years to avoid water leaks.from 1 € 0.82 incl. 19% VAT
€ 0.69 -
Washer Ø4,3xØ20x1,25 DIN 522 for the fin tank dump valve
This washer is used for the tail ballast dump valve of most of the Schempp-Hirth gliders.from 1 € 0.24 incl. 19% VAT
€ 0.20 -
Brass bushing for the lower rudder framework fin of the Ventus a, b, and c and Discus a and b
This brass bushing is part of the lower framework of the rudder fin on Ventus a, b and c, and the Discus a and b.
Careful: on rare cases, gliders need a slightly larger head: 2 mm instead of 1 mm (see picture). Please look carefully at your actual part to buy the same model. If you need the 2 mm version, please contact us.
On more modern gliders the diameter of the head is 16 mm instead of 14 mm. You cannot use one for the other.
from 1 € 8.03 incl. 19% VAT
€ 6.75 -
Horizontal tailplane mounting tool with extra pin for wingtip mounting
The Schempp-Hirth iconic tool with an extra pin to dismantle the wingtip.from 1 € 23.78 incl. 19% VAT
€ 19.98 -
Horizontal tailplane mounting tool, with Ventus-3 extras.
The Schempp-Hirth iconic tool with an extra pin to dismantle the wingtip and an extra tool for the ballast plugs.from 1 € 71.39 incl. 19% VAT
€ 59.99 -
Steel bushing for rudder cable
This steel bushing, 8x1x7 mm without hole, is used for rudder cables.
They are sold individually.
The screw, washer and lock nut can be added as an option.
The EASA form one is included.
from 1 € 5.46 incl. 19% VAT
€ 4.59 -
Single seater horiz. tailplane sealing for Ventus-3 Sport
This sealing is critical to limit the ageing of the horizontal tailplane fixation mechanisms. We advise you to renew it every couple of years.
The form is 94,98 x 370,00 mm. It is designed for the Discus-2a, -2b and the Ventus-3 Sport. It may also be possible to adapt it for older gliders. If you prefer, you can make the form yourself using a Tesa Foam roll.
from 1 € 13.52 incl. 19% VAT
€ 11.36 -
Schnorr-safety washer
Safety washers Form S available in M6 and M8.
These washers are used, among other things, to secure the rear part of the horizontal tail fitting and the elevator drive U-bracket.
from 1 € 0.48 incl. 19% VAT
€ 0.40
Help, my spare part is not yet in the shop!
If you cannot find the item you want please use the spare-part form and we will come back to you shortly.