Solo2625-02i
-
Fuel Tank for Arcus M for replacement
This item will allow you to replace the wing fuel tank of your Arcus.
from 1 € 1,482.48 incl. 19% VAT
€ 1,245.78 -
Water pump for SOLO 2625
This water pompe is used for all the SOLO engines 2625.from 1 € 652.24 incl. 19% VAT
€ 548.10 -
KIT for fuel hose replacement at the 5-year inspection for Arcus M
This kit contains all the fuel hoses that need to be replaced during the 5 years inspection on the Arcus M.from 1 € 503.85 incl. 19% VAT
€ 423.40 -
RPM sensor, with pins, for Arcus M
This RPM sensor with cables and pins is used for the Solo 2625-02i.
from 1 € 300.76 incl. 19% VAT
€ 252.74 -
V-belt for Arcus M SOLO 2625-02i
This item is 1 set of 5 pieces.
SOLO spare-part n° 00 57 224
from 1 € 273.51 incl. 19% VAT
€ 229.84 -
fuelling hose, assembled, all models
This hoses are assembled with a filter and the connections to refuel your glider.
from 1 € 208.23 incl. 19% VAT
€ 174.98 -
Ignition coil for Solo 2625 type "i" from PVL
The ignition box from PVL is used for the Solo 2625-01i and 2625-02i but not for the other version. The Solo 2625-01 and 2625-02 need the ignition coil from Ducati.from 1 € 192.22 incl. 19% VAT
€ 161.53 -
Rubber element of the spindle suspension for almost all M
This part is used for the Discus bM, the Ventus-2cM, the Ventus-3M, the Nimbus-4DM and the Arcus M.from 1 € 177.57 incl. 19% VAT
€ 149.22 -
Limit switch IX02 0815
This proximity switch (ref IX02 0815) is used for the automatic propeller brake in the Arcus M.
It is not addapted to the Arcus M edition 2020.
This position sensor is sold as a unit (you might need two of them) and the FUT plug is included.
from 1 € 140.04 incl. 19% VAT
€ 117.68 -
Rubber element for the almost all modern engine mounts
This rubber element is use for the engine mount of the Arcus M, the Ventus-3M, Ventus-2cM, the Ventus-2cxM, the Nimbus-4M and the Nimbus-4DM.
Its old reference is VW 431407181D.
from 1 € 88.33 incl. 19% VAT
€ 74.23 -
Self sealing coupling for the Ventus-3M and Arcus M
This coupling is used for the fuel line going to the wing tank of the Ventus-3M and the Arcus M.
Please make sure you are entitled and have the skills to change that part. It should be secured with Loctite 577.
Please note: The coupling for the vent line is different.
from 1 € 85.17 incl. 19% VAT
€ 71.57 -
Kit pylon arresting wire for Ventus- 2cM, Ventus-3M, Arcus M, Nimbus-4M and -4DM
The kit contains the cable (diameter 3,2 mm), 2 nicopress-oval sleeves, 2 thimbles and some silicone tube. One side is already assembled.
It can be use for the Ventus-2cM, Ventus-3M, the Nimbus-4M and -4DM and the Arcus M.
Please refer to the maintenance manual for the installation.
from 1 € 66.70 incl. 19% VAT
€ 56.05 -
Ignition wire for Arcus M
This ignition cable is 35 cm long and it is used for the Arcus M.
You will need 4 units. if you want to change all of them.
from 1 € 63.87 incl. 19% VAT
€ 53.67 -
Spark plug connector 5k Ohm
This gummi piece is used to connect the spark plug in the SOLO 2625 and 2350 engines.
SOLO spare part n° 23 00 701 V1
This part used to be black. The old model is no longer available and it is replaced by this new reference.
from 1 € 52.59 incl. 19% VAT
€ 44.19 -
Spindle suspension with bushing
This rubber element is part of the spindelsuspension of the Ventus-2cM, Ventus-3M, Nimbus-4M, -4DM and Arcus M.
It is 34 mm long.
Depending on the equipment available to you, it might be easier to buy the complete part (B40-13772). See suggested products.
from 1 € 42.84 incl. 19% VAT
€ 36.00 -
Fuel filters for Arcus M
These filters (1 filter Pierburg 4.00030.80.0 and 1 filter KL14 Mahle) are used for the fuel system of the Arcus M.from 1 € 41.77 incl. 19% VAT
€ 35.10 -
Screw for the rear spindle suspension of almost all the M
This screw is M10 x 58.
It is used for the rear spindle suspension of des Arcus M, Nimbus-4DM, Ventus-3M und Ventus-2cM
from 1 € 26.18 incl. 19% VAT
€ 22.00 -
Exhaust gasket for Solo 2625
Gasket exhaust is used for the SOLO engines 2625.
It is 68,5 x 48 x 2 mm.
It is sold by the unit.
from 1 € 23.53 incl. 19% VAT
€ 19.77 -
Brass bushings for propeller stopper for the Ventus-3M and Arcus M edition 2020
These three brass bushes are used for the propellor stopper of the Ventus-3M and the Arcus M edition 2020. The bush in the centre is 8 x 1 x 9.3 mm and the two on the side are 8 x 1 x 6.7 mm.
They can be damaged by the spring and this creates some play in the stopper.
from 1 € 23.43 incl. 19% VAT
€ 19.69 -
Fuel hose
This hose NW 4,8x1,6 mm is transparent and it is use for the Fuel sytem.
It is sold my the meter.
from 1 € 20.72 incl. 19% VAT
€ 17.41 -
Rubber buffer 20x25, M6x18 for the radiator of the Ventus-2cM and Nimbus-4DM.
This silent block is used for the cooler of the Ventus-2cM, Nimbus-4DM and Arcus M engine.
The head is 25 mm and the screw 18 mm. Its diameter is 20 mm.
Look at the model(s) that you want to replace and order the same. According to your glider, you might also want this rubber buffer.
from 1 € 9.21 incl. 19% VAT
€ 7.74
Help, my spare part is not yet in the shop!
If you cannot find the item you want please use the spare-part form and we will come back to you shortly.