Spare parts

This washer is  16 x 2 x 4,5 mm and it is used for the tail wheel 

This washer is  16 x 2 x 5,5 mm and it is used for the tail wheel. 

This wingtip wheel axle is used for the Arcus and Ventus-2c.

The safety ring spring can be found in the suggested products below.

These replacement springs are specifically designed for use with the BWS Flexiwiper system. Each set is sold as a matched pair, for the left and right Flexiwiper unit.

Important compatibility note:
These springs are not compatible with the Ventus-3 or Arcus edition 2020 Garagewipers models. 

These replacement springs are specifically designed for use with the BWS Garagewiper system. Each set is sold as a matched pair for the left and right wiper units.

Important compatibility note:
These springs are not compatible with the classic Flexiwiper model.

This M8 screw is design for the steering tail wheel axle of the Arcus-M and the Ventus-3M.

 

This rubber boot ensures the sealing of the tail ballast of most of the Schempp-Hirth gliders.
It is advisable to replace it every 2-3 years to avoid water leaks.

Its dimensions are 72 x 38 mm.

This handle for the trim is a format 25 mm, M6. It is made in aluminium and green powdered.

This tension spring is used to maintain the flap handle on the right position. 

On the Janus B and Nimbus-2, it is located near the front seat handle.

Originally, the Janus C, the Nimbus-3D and the Nimbus-4D are using another spring that looks very different (ref B40-2417) and that is located on the back seat cockpit wall. However some gliders have been modified and they are now using this flat spring but near the spar bridge.

The other reference is available below under the suggested products.